Wedding bouquet with your own hands

Want to create your own bridal bouquet? From single stem to blossoming bushel, just follow these simple instructions for a classic dome shaped wedding bouquet.



A simple single-flower wedding bouquet is not difficult to make, and the classic dome shape of this round bridal bouquet complements most wedding gowns. Be sure to stick to hardier flowers like roses, which are easier to arrange and can endure a little manhandling. To make a bridal bouquet about 8 inches in diameter, just follow the instructions below. This bouquet takes between 30 and 60 minutes to construct, and about 30 to 60 stems.



What You'll Need


  • 30 to 60 stems of a hardy flower like the rose (20 to 40 for each bridesmaid bouquet).
  • Bucket
  • Paper towels
  • Ribbon (in a complementary color), 1 to 2 inches wide
  • Rubber bands or green waxed floral tape
  • Stem cutter or very sharp knife
  • Stem stripper
  • Straight pins or pearl-tipped corsage pins


Use your hands or a stem stripper to remove excess foliage and thorns, and pull off damaged or unattractive outer petals.

Fill a sink or bucket with water, and holding the stems underwater use the stem cutter or knife to cut the stems at an angle about 2 inches from the bottom.

Allow the flowers to drink for a few seconds with the stem ends underwater, then place the stems in a bucket filled halfway with cool water until you are ready to use them.

Knot Note: If you're working with roses and the heads aren't open yet, you can force the blooms open by placing the stems in a bucket of hot water; but only do this for a couple of minutes just before you are going to use the roses, or you might kill them otherwise.

Keep the stems long while you work with them and trim them to a shorter length when you've finished constructing the bouquet.

Take one stem at a time with one hand, and use your other hand to hold the flowers in place

Assemble four flowers at an even height in a square shape -- these will be at the center of the dome.

Arrange the other flowers one by one around the center flowers to create a dome shape. See other wedding bouquet shapes.


To better see what the bouquet will look like in your hand, stand in front of a mirror as you construct the bouquet to observe how the shape is progressing.


Use a rubber band or floral tape to bind the stems at the spot where they naturally join (about 3 to 4 inches below the flower heads).

Repeat the binding toward the end of the stems, leaving about 2 inches of excess stem beneath the bind to trim later.

Either place the stems in water and wrap them later